Bass Truss Rod Adjustment: How to Check and Set Neck Relief
A bass truss rod adjustment changes the neck relief, the slight forward bow the neck takes under string tension. Tighten the rod (on most basses, clockwise) when the strings sit too high in the middle of the neck, loosen it (counterclockwise) when the low frets buzz, and never turn it more than a quarter turn at a time.
I’ve played bass since 2001 and taught more than 750 students, and a bass that is hard to play is one of the most common reasons beginners decide they have no talent. Very often the problem is the setup, not the player, and the truss rod is the first step of every setup. This guide explains what the rod does, how to check whether your bass needs an adjustment, and how to make one without damaging the neck.
Free: Slap Bass Starter Pack
5 video lessons with slow-motion takes, drum loops and tabs. Enter your email and download it right away.
What Does a Truss Rod Do on a Bass?
Bass strings pull hard on the neck, and that pull bends the neck forward. The truss rod is a steel rod that runs inside the neck and works against the strings. Tightening it straightens the neck, and loosening it lets the strings pull a little more bow into it.
That small forward bow is called relief. A neck with a little relief gives the strings room to vibrate in the middle of the fretboard without hitting the frets. A neck that is dead straight or bent backward tends to buzz on the low frets, and a neck with too much bow makes the strings sit high around the middle of the neck, so every note there takes more effort to press.
One thing the truss rod is not for is setting the string height. Action is set at the bridge saddles. Using the rod to lower the strings is a common mistake, because it fixes one problem by creating another one in the curve of the neck.
How Do You Know if Your Truss Rod Needs Adjusting?
The neck tells you through the way the bass plays. These are the symptoms I would check before touching anything else:
| What you notice | Likely cause | What to do |
|---|---|---|
| Buzz on the first few frets on several strings, action looks fine at the 12th fret | Too little relief, or the neck is bowed backward | Loosen the rod slightly |
| Strings feel high and stiff around frets 5 to 9, fine near the nut | Too much relief | Tighten the rod slightly |
| Buzz on one fret or one string only | A high fret or a worn nut slot, not the rod | Take it to a technician |
| The bass played well, then changed after new strings | A different string gauge pulls the neck differently | Check relief and adjust if needed |
| The feel changes when the seasons change | Humidity moves the wood of the neck | Check relief when the weather turns |
If you have just changed to a heavier or lighter set, or you started tuning down, read my bass strings guide as well, because the gauge decides how hard the strings pull on the neck in the first place.
How Do You Check Neck Relief on a Bass?
You only need a capo, a feeler gauge if you have one, and the bass tuned to the pitch you normally play at. Measure on the E string, or on the B string if you play a five-string.
- Tune the bass to pitch with the strings you actually use.
- Put a capo on the 1st fret, or hold the string down there with one finger.
- Hold the bass in playing position and press the same string down at the last fret.
- Look at the gap between the bottom of the string and the top of the 8th fret.
capo at fret 1 fret the E string here (last fret)
| |
=====|==============================================|==== E string
|____________ measure the gap here ____________|
(top of the 8th fret)
Fender’s bass setup guide gives about .012 inch (0.3 mm) of relief at the 8th fret for necks with a 9.5 to 12 inch fingerboard radius, and about .014 inch (0.35 mm) for vintage-style 7.25 inch necks. Fender itself presents these as guide figures. Players with a light right hand often like a little less relief, and players who dig in hard usually want a little more.
No feeler gauge? Keep both points pressed and tap the string over the 8th fret with a free finger. A small gap and a tiny click mean there is some relief. If the string already touches the fret and does not move at all, the neck is straight or bowed backward, and that is the usual source of buzz on the low frets.
Which Way Do You Turn a Truss Rod?
Look straight at the adjustment nut, whether it sits at the headstock or at the body end of the neck. On most basses:
- Clockwise tightens the rod, reduces relief and brings the strings closer to the frets in the middle of the neck.
- Counterclockwise loosens the rod, adds relief and gives the strings more room.
Some basses have a dual-action rod, which can push the neck in both directions. On those, loosening past the neutral point does not make the rod go slack, it starts adding bow, so read the manual for your model before you turn anything.
Where the nut sits depends on the design. Most modern basses have it at the headstock, under a small cover or in a slot behind the nut. Many vintage-style Fender designs put it at the heel, where the neck meets the body, and you may need to loosen the neck to reach it. Some basses, including current Ernie Ball Music Man models such as the StingRay, use a wheel at the end of the fingerboard that you turn with a small rod or hex key.
Use the key that came with the bass, or exactly the size the maker lists. A worn or slightly wrong key rounds off the nut, and a rounded truss rod nut turns a five-minute adjustment into a repair.
How Do You Adjust a Bass Truss Rod, Step by Step?
- Measure the relief first and write the number down, so you know what you are changing.
- Slacken the strings a little if your maker says so. Fender recommends loosening the strings before a truss rod adjustment, so the rod turns without fighting the full string tension, while some other makers say to adjust at pitch. Your manual decides.
- Turn the rod a quarter turn at most. An eighth of a turn is often enough.
- Tune back to pitch and play for a few minutes.
- Measure again. A neck can keep moving for a while after an adjustment, so check once more later in the day before you make another turn.
- Repeat in small steps until the relief is where you want it.
If the rod feels very stiff, stop. Yamaha’s own advice is to stop tightening if you feel heavy resistance, and if the rod reaches the end of its travel before the neck is right, the bass needs a technician rather than more force.
What Should You Adjust After the Truss Rod?
The order matters, because each step changes the next one. Set the relief first, then the string height at the bridge saddles, then the pickup height, and the intonation last. If you set the intonation first and then change the relief, you will have to do the intonation again.
This is the same sequence a technician follows in a full setup. In my guide to the best bass guitar for beginners I say that a cheap bass with a proper setup plays better than an expensive one without it, and the truss rod is where that setup starts.
How Often Should You Adjust the Truss Rod?
There is no fixed schedule. Check the relief when the seasons change, when you change string gauge or tuning, when you buy a used bass, and whenever the bass starts to feel different under your hands. Some necks need a small tweak at every change of weather, others stay put for years. Checking takes a minute, so it is worth doing every time you change strings.
When Should You Take Your Bass to a Technician?
- The rod will not turn, or it feels like it is about to give.
- The rod is at the end of its travel and the neck still has too much bow.
- The relief is different on the E string side and the G string side, which points to a twisted neck.
- One fret buzzes no matter what you do with the rod.
- The adjustment is at the heel and you are not comfortable taking the neck off.
A setup at a guitar shop is not expensive, and in my article on how much a bass guitar costs I count it as part of the price of any new instrument. The full setup, step by step, is in my guide to bass guitar setup, and if a buzz stays after the rod is right, my guide to bass fret buzz helps you find where it comes from. If you are just starting out and want to know what a good playing feel is in the first place, my guide on how to play bass guitar covers the basics of both hands.
Frequently Asked Questions
Which way do I turn a bass truss rod?
On most basses, turning the nut clockwise (as you look straight at it) tightens the rod and reduces relief, and counterclockwise loosens it and adds relief. Dual-action rods can behave differently past their neutral point, so check the maker’s manual for those.
How much neck relief should a bass have?
Fender’s bass setup guide lists about .012 inch (0.3 mm) at the 8th fret for 9.5 to 12 inch fingerboard radius and about .014 inch (0.35 mm) for 7.25 inch radius, measured with a capo at the 1st fret and the string held at the last fret. Treat those numbers as a starting point and adjust to your touch.
Does the truss rod change the action on a bass?
Only in the middle of the neck, and only as a side effect. The truss rod sets the curve of the neck. The string height itself is set at the bridge saddles, after the relief is right.
Should I loosen the strings before adjusting the truss rod?
Fender recommends it, because slack strings take the load off the rod so it turns more easily. Not every maker gives the same advice, so follow the manual for your bass. Either way, tune back to pitch before you measure again.
Can you break a truss rod by turning it too far?
Yes. Forcing a tight rod can strip the nut or snap the rod, and that is an expensive neck repair. Turn a quarter turn at most, and stop if the rod feels very stiff.
Why does my bass buzz after a truss rod adjustment?
Usually the neck now has too little relief, so the strings hit the low frets. Loosen the rod a little, retune and check again. If the buzz is on one fret only, the cause is more likely a high fret, which a technician fixes.
New to Bass? Start Here
Start free with my step-by-step guide on how to play bass guitar and the free Slap Bass Starter Pack. After your first few weeks, send me a video of your playing for a $25 review, and I will show you what to fix before bad habits set in. If you would rather learn with a teacher live, book a 60-minute lesson over Zoom.
Free Slap Bass Starter Pack →Video review, $25 →Live lesson, $60 →